Scheppach HSM3500 Traduccion Del Manual De Instrucciones Originale página 32

8. Before start-up
Please read the instructions in the present manual
carefully before using the tile-cutting machine.
Read the Instructions For Use:
Please read the Instructions for Use carefully before
setting up, commissioning or intervening in the ma-
chine.
Dangerous electric voltage
Caution! Switch off the mains power supply before
making any intervention in the tile-cutting machine.
Risk from sudden start
Caution! The tile-cutting machine can restart suddenly
after a power failure.
Replace cracked diamond cutting discs.
• Get to know your machine. Familiarize yourself with
its use and its restrictions, but also with the specific
potential risks.
• Check the machine carefully for damages to ensure
that it is able to achieve the intended output. In case
of doubt, please replace the concerned component.
• Ensure that the switch is on Off, before inserting the
power plug into the mains socket.
• Ensure that the machine is cleaned and lubricat-
ed properly.
• Before start-up, check the machine for damaged
parts and find out whether these parts are work-
ing properly and performing their defined function.
• Check the alignment of all moving parts, all broken
or fastening parts, and all other conditions that can
affect smooth operation. Each damaged part should
be repaired or replaced by a technician immediately.
• Do not use the machine if a switch cannot be acti-
vated/deactivated correctly.
9. Operation
• Install the machine on an even, slide-proof floor.
• Check that the voltage on the nameplate matches
the existing voltage; connect the power plug to the
mains power supply only thereafter
• The cutting disc should be free to run before the
machine is switched on.
Caution: Cutting disc must always be cooled with wa-
ter.
32 | GB
Caution: Cutting disc runs with a time lag.
Do not break the cutting disc by applying pressure at
the sides.
• Under normal use conditions, the motor casing can
become hot.
• Do not use force on the machine or on an accesso-
ry to achieve the performance of a bigger Industrial
machine. It does a better job at the output for which
it is designed.
• Define all machine settings only when it is switched
off.
• Do not leave the machine unattended as long as
it is running.
• During shutdown, leave the machine only after it
comes to a complete standstill.
• Always switch the machine off before pulling out the
power plug from the mains socket.
• Always pull out the power plug. Never disconnect
the power plug from the mains socket by pulling at
the cable.
• Do not use cutting discs that do not meet the size
specifications.
• Do not carry the machine by the cable.
Do not work with the machine if you are not sure
whether a working condition is safe of unsafe.
10. Assembly
10.1 Fig. 4 - 10
For packaging purposes, your machine is not fully as-
sembled.
At least two people are required to install the device!
1. Carefully remove the machine from the packaging
and set it aside on the ground.
2. First fold the foot (11), on the side without trans-
port wheels, outwards as far as it will go until the
screw engages in the oblong hole as shown in Fig.
7. Make sure that the foot is locked in place and
does not fold in again!
3. Repeat the procedure for the second foot (Fig. 8).
4. Place the machine on the feet.
5. Place the water pump (18) in the holder of the wa-
ter tube and insert the sealing plug (s) in the drain
of the water tube (8). (Fig. 9,10)
6. Fill the tube with water so that the pump (18) is cov-
ered with water at all times (also during operation).
Attention!
The water pump may never run dry. It must always be
covered with water during operation.
www.scheppach.com