Publicidad
Idiomas disponibles
Idiomas disponibles
Interruption of power supply or failure of the refrigerating system
•Take care of the frozen foods in the event of an extended non-running of the refrigerating appliance (such as interruption
of power supply or failure of the refrigerating system).
•Try to open the refrigerator door as less as possible, in this way can food safely and freshly kept for hours even in hot
summer.
•If you get the power outage notice in advance：
1)
Adjust the thermostat knob to the high mode an hour in advance, so that foods get fully frozen (Do not store new
food during this time!). Restore the temperature mode to the original setting when power supply becomes normal in a
timely manner.
2)
You can also make ice with a watertight container, and put it in the upper part of the freezer, so as to extend the time
for fresh food to be stored.
Note: Once the refrigerator is used, you'd better use it continuously; and under normal circumstance, do not
stop its use, so as not to affect the service life.
Defrosting
After a period of use, a thin layer of frost will be formed on the freezer compartment inner wall (or evaporator) surface,
which may affect the refrigeration effect if exceeding 5mm in thickness. In such case, you need to gently scrape the frost
off using an ice scraper rather than the metal or sharp hardware. Frosts need to be cleared off every 3 months or so, and if
the normal use of drawers and normal access of foods are affected by frosting, make sure to remove the frosts in a timely
manner. Follow the following steps to remove frosts:
1. Take out the frozen foods, shut off the mains power supply, open the refrigerator door, and gently remove the frosts
from the inner wall with an ice scraper. To speed up the thawing process, you are suggested to place a bowl of hot water
inside the refrigerator/freezer, and when the solid ice frosts become loose, use an ice scraper to scrape them off and then
take them out.
2. After defrosting, clean the refrigerator/freezer inside, and switch on the power supply.
Changing the light
The LED lamp is used by the refrigerator for lighting, which features low energy consumption and long service
life. In case of any abnormality, please contact the after-sales personnel for visiting service.The LED lamps can
only be replaced by the after-sales personnel.
Lamp type：LED light.
Energy efficiency level： G
Note: Electric shock and fire accident may be caused in case the power cord and plugs damaged or stained
by dust. If any abnormality, please unplug the power plug and get in contact with the vendor.
VIII.
Simple fault analysis and elimination
With regard to the following small faults, not every failure needs to be fixed by the technical service personnel; you can try
to solve the problem.
Case
•
Completely
non-refrigeration
•Abnormal noise
•
Poor
refrigerating
efficiency
•Peculiar smell in
refrigerator
Note: If the above descriptions are inapplicable to troubleshooting, do not disassemble and repair it yourself. Repairs
carried out by inexperienced persons may cause injury or serious malfunctioning. Contact the local store where your
Inspection
• Is power plug off?
• Are breakers and fuses broken?
• No electricity or line trip?
• Where is the refrigerator installed? Is it
placed in balconies, garages, storage rooms
and other places where the ambient
temperature is below 10℃?
• Is refrigerator stable?
• Does refrigerator reach the wall?
• Do you put hot food or too much food?
• Do you open the door frequently?
• Do you clip food bag to the seal of door?
• Direct sunlight or near a furnace or stove?
• Is it well-ventilated?
• Temperature setting in too high?
• Any spoiled food?
• Do you need to clean refrigerator?
• Do you pack food of strong flavors?
Solutions
• Re-plug
Opening the door and checking whether the lamp
•
is lit.
Power outage or line tripping?
•
• Install refrigerator in a location that is protected
and
the
ambient
10 ℃ .If your refrigerator is installed in too low te
mperature,the internal cooling system may not wo
rk correctly.
• Adjusting refrigerator's adjustable feet.
• Off the wall.
• Putting food into refrigerator when hot food
becomes cool.
• Checking and closing the door.
• Removing the refrigerator from the heat source.
• Emptying the distance to maintain good
ventilation.
• Setting to the appropriate temperature.
• Throwing away spoiled food.
• Cleaning refrigerator.
• Packing food of strong flavors.
10
temperature
is
above
Publicidad
