ResMed 370003 Guia Del Usuario

English | Deutsch | Français | Italiano | Español | Português | Nederlands | Svenska | Dansk | Norsk | Suomi |
C
B
ENGLISH
The Air10™ DC/DC Converter 90W (model no. 370003)
allows you to operate your device from a vehicle cigarette
lighter socket (12V or 24V DC power source) in a car, boat,
or other vehicle equipped with a suitable battery.
The Air10 DC/DC Converter 90W (model no 370003) is
specifically for use with the AirSense™ 10, AirCurve™ 10
and Lumis™ device.
Consult your equipment supplier for more information
about this accessory.
Using the converter via a vehicle cigarette
lighter socket
Refer to Illustration at the beginning of this document.
1. Before connecting the converter, make sure the
converter switch (A) is off.
2. Position the converter on a level surface, with the
ResMed logo facing up.
3. Plug the converter connector (B) into the device power
inlet/DC input socket (C).
4. Remove the cigarette lighter from the vehicle cigarette
lighter socket.
5. Plug the converter adaptor plug (D) into the vehicle
cigarette lighter socket.
6. Switch on the converter. The light (E) will glow green
when it powers on.
The light will flash continuously if the connection is not
made, or if the device is in standby or power save mode
E D A
Air10 DC/DC Converter 90W
Česky | Eesti |
when the connection is made. If the battery is low,
the light will glow amber. If the light does not operate,
check that the converter switch (A) is on.
Notes:
• Some vehicles require the ignition key to be turned
to the "accessories" position to provide power to the
vehicle cigarette lighter socket.
• If you connect your device to a powered converter, the
converter may power down. To resume power, turn the
converter off and on again.
• The power cord is not replaceable.
• If the battery OR car, boat or other vehicle are not in
good condition, there may not be enough reserve left in
the battery to start the vehicle after use.
• The Air10/ Lumis device with the HumidAir
attached uses considerably more power than the Air10/
Lumis device alone. Using the HumidAir humidifier will
drain the battery more quickly.
• If the converter cuts power to your device when
starting your car, boat or other vehicle, disconnect the
converter from the vehicle. Wait a few seconds and
then reconnect it.
• When the converter is not in use switch the converter
off or disconnect it from the vehicle cigarette lighter
socket to prevent battery discharge.
• If you need help, contact a ResMed representative,
ResMed Technical Services or see www.resmed.com.
Cleaning
If necessary, wipe the outside of the converter with a
clean, damp cloth.
WARNINGS
• Read instructions before use.
• Only use the converter when connecting to a 12V or
24V DC supply.
• Do not attempt to modify the converter. There are
no user-serviceable parts inside the converter.
CAUTIONS
• The Air10 DC/DC converter must only be used with
AirSense 10/ AirCurve 10/ Lumis devices to ensure
proper performance.
• The converter is intended for use on 12V or 24V
negative ground systems (where the negative
terminal of the battery is grounded). Using it on a
12V or 24V positive ground system may damage
the converter and the vehicle's electrical system. If
you are unsure whether you have a negative ground
system, consult the car, boat or other vehicle
manual.
User Guide
| |
日本語
简体中文
繁體中文
humidifier
™