golmar Stadio Plus T500SE ML Manual De Instalación página 63

TELEPHONE INSTALLATION
F
ix the telephone to the wall .
It is necessary to open the telephone for wiring and fixing
purposes To open the telephone, insert a plain screwdriver
into the slots and gently lever as shown in the drawing
Avoid placing the telephone near sources of heat, in dusty
locations or smoky environments The telephone can be .
fixed using an electrical embedding box or directly on the
wall, as shown on the picture If the telephone will be .
installed directly over the wall, drill two holes of Ø6mm on
the specified positions, using 6mm wall plugs and Ø3.5 x
25mm screws .
P ass the installation wires through the corresponding hole and connect
them as shown on the installation diagrams
shown on the picture Once the telephone is closed, connect the
handset using the telephone cord and put it on the cradle
123
.
.
. C lose the telephone as
.
.
124
TELEPHONES PROGRAMMING
P
rogramming the T-740 Plus telephones.
Set to ON the switch number 2 of the SW2 configuration dip switch, that's
accessible in the EL500SE module by opening the terminal connector protection
cover. The door panel will reproduce a sound to advise that the system has
entered into programming mode. In systems with more than one door panel,
the programming process shall be done on the master door panel only.
To program the telephone from a general door panel (if it exists), see page 112.
SW1
1 2
P3
1 2
P3
ON
P3
ON
P3
M
ON
CN1 P1
SW1 P3
ON
P3
P2
S
ON
CN1 P1
SW1
P3
ON
P3
P2
SI
ON
CN1 P1
SW1
P3
ON
P3
P2
Each apartment must have one master unit only; in case of parallel units configure them as slaves,
both monitors or telephones.
Make a call to check that the telephone has been succesfully programmed. Repeat
these steps to program the rest of telephones.
Once the programming has been finished, set to OFF the programming switch. If
you don't, the door panel will reproduce a tone to advise that the system is still
into programming mode.
Open the telephone to programming (see page
123). Select in the SW1 dip switch the fuction
mode for the auxiliary function push button
(see page 122) and later press the P3
programming push-button.
To show that the system is ready for programming,
the door panel and the telephone's handset will
reproduce a tone (the telephone led will light).
Audio communication can be established.
Press the door panel push button that will call to
this telephone. At this moment both door
panel and handset will reproduce tones (the
telephone led will slow blink).
To programm the telephone as Master, press the
h ook switch (the telephone led will off).
Close the telephone.
To programm the telephone as Slave, press the
CN1 P1
P1 door release push button (the telephone
led will quick blink) and later press the hook
P2
switch (the led will off).
Close the telephone.
To programm the telephone as Slave +
CN1 P1 Intercom., press the P2 auxiliary function
push button (the led will quick blink) and later
P2
press the hook switch (the led will off).
Close the telephone.