Sauder worksense Mason Peak Serie Instrucciones De Montaje página 10

Step 4
å
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as shown in the upper
diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (35MA) to the LEFT END (B) and UPRIGHT (H). Use four GOLD 5/16"
FLAT HEAD SCREWS (3S) through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then,
slide the inner cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in
the END or UPRIGHT. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWER.
35MC
Push the black lever in and pull the SLIDE from the RAIL.
Open end
Page 10
3
B
2
1
35MA
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
H
427836
7
3S
Open end
1
2
3
www.sauder.com/officeservice