Publicidad
Idiomas disponibles
Idiomas disponibles
Precaution
Resetting the microprocessor
CAUTION
Pressing the RESET button resets settings and recorded
contents to the factory settings.
Do not perform this operation when a device is connected
●
to this product.
Some of the settings and recorded contents will not be
●
reset.
The microprocessor must be reset under the following
conditions:
Prior to using this product for the first time after installation.
●
If this product fails to operate properly.
●
If there appears to be problems with the operation of the
●
system.
If your vehicle position is shown on the map with a signifi-
●
cant positioning error.
1 Turn the ignition switch OFF.
2 Press the RESET button with a pen tip or other
pointed implement.
Checking part names and functions on page 8
Settings and recorded contents are reset to the factory settings.
About this manual
This manual uses diagrams of actual screens to describe opera-
tions. However, the screens on some units may not match those
shown in this manual depending on the model used.
Meanings of Symbols Used in This
Manual
This indicates model name that are supported
X7750BT
the described operations.
This indicates to touch an appropriate soft key
on the touch screen.
This indicates to touch and hold an appropriate
soft key on the touch screen.
HOLD
This indicates that there is a reference or
supplementary for the key or screen.
6
< CRD4831-A >
6
Protecting your unit from theft
The front panel can be detached to deter theft.
Important
Handle the front panel with care when removing or
●
attaching it.
Avoid subjecting the front panel to excessive shock.
●
Keep the front panel out of direct sunlight and high
●
temperatures.
If removed, replace the front panel on the unit before
●
starting up your vehicle.
To avoid damaging the device or vehicle interior, remove
●
any cables and devices attached to the front panel before
detaching it.
Removing the front panel
Pinch the top and bottom of its right side and
pull the front panel out.
Take care not pinch it too tightly or to drop it, and also avoid
contact with water or other fluids to prevent permanent damage.
Re-attaching the front panel
1 Slide the front panel to the left.
The front panel and the head unit are connected on the left side.
Make sure that the front panel has been properly connected to
the head unit.
2 Press the right side of the front panel until it is
firmly seated.
If you can't attach the front panel to the head unit successfully,
try again.
Forcing the front panel into place may result in damage.
Use and care of the remote
control
Installing the battery
Slide the tray on the back of the remote control out and insert the
battery with the plus (+) and minus (–) poles aligned properly.
When using for the first time, pull out the film protruding
●
from the tray.
WARNING
Keep the battery out of the reach of children. Should the
●
battery be swallowed, consult a doctor immediately.
Batteries (battery pack or batteries installed) must not be
●
exposed to excessive heat such as sunshine, fire or the
like.
CAUTION
Remove the battery if the remote control is not used for a
●
month or longer.
There is a danger of explosion if the battery is incorrectly
●
replaced. Replace only with the same or equivalent type.
Publicidad
