70mai A810 Serie Manual Del Usuario página 4

Installation
1. Installing the
electrostatic sticker
Paste the electrostatic sticker
on the recommended area on
the front windshield. Press the
sticker to remove air bubbles
out.
Avoid the edge of the windshield and select the flat and
smooth area for the installation.
Note: Keep windshield clean and dry without liquid residue to
prevent the sticker from losing adhesion and dash cam from
dropping.
2. Installing the mount
Attach the mount into the mount
slot and slide up.
3. Installing the memory card
Insert the memory card into the card
slot.
4. Mounting the dash cam
Paste the dash cam onto the
electrostatic sticker.
5. Routing cable
Route the power cord to the
cigarette lighter and connect
power.
Notes:
•
Use the included wiring trim tool to hide the power cord
underneath the vehicle's headliner and rubber seal along the
A-pillar.
•
Depending on the vehicle, the cigarette lighter socket may
be located in a different position. The above figure is for
reference only.
6. Adjusting the camera angle
Turn on the dash cam and adjust the
camera angle based on the preview
screen.
02