Publicidad
Idiomas disponibles
Idiomas disponibles
11
10
14
12
13
15
24
CONTENT
STRAPPING WITH VEHICLE SEAT BELT
Place your child in the child seat. Pull the three-point
belt right out and feed it along the belt buckle 10 in
front of your child.
WARNING! Never twist the belt.
Insert the belt tongue 11 into the belt buckle 10. It must
lock into place with an audible "CLICK" . Next, place the
lap belt 12 in the lower green belt guide 13 of the child
seat. Now pull the diagonal belt 14 firmly to tighten
the lap belt 12. The tighter the belt sits, the better it
provides protection from injury.
NOTE! On the side of the belt buckle 10, the diagonal
belt 14 and the lap belt 12 must be inserted together in
the lower belt guide 13.
WARNING! The vehicle belt buckle 10 must never
cross the arm rest. If the belt system is too long,
the child seat is not suitable for use in this position
in the vehicle. In case of doubt, please consult the
manufacturer of your vehicle.
The lap belt 12 should have been fed through the lower
belt guides on both sides of the seat cushion.
NOTE! Teach your child from the start to always ensure
that the belt is tight and, if necessary, how to tighten
the belt themselves.
10
WARNING! The lap belt 12 must run as low as
possible on both sides along your child's groin to have
optimum effect in the event of an accident.
Now feed the diagonal belt 14 through the green upper
belt guide 15 in the headrest until it is inside the belt
guide. Ensure that the diagonal belt runs between the
outside of the shoulder and the neck of your child.
If necessary, adjust the height of the headrest 7 to
change the position of the belt. The height of the
headrest can still be adjusted while in the car.
Publicidad
