Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE
If the appliance is used regularly, it is advisable to always have a replacement
limescale filter available. This means that you can replace the limescale filter
immediately as soon as the "anti calc" indicator lamp
You can order new limescale filters
section Ordering replacement parts).
1) Switch the appliance off using the On/Off button
down.
2) Remove the power plug from the mains power socket.
3) Remove the iron from the base station and put it to one side.
4) Open the shaft cover
5) Pull the limescale filter
6) Place the new limescale filter
until it is firmly seated.
7) Close the shaft cover
8) Insert the plug into a mains power socket and switch on the appliance using
the On/Off switch
9) Press the "RESET" button
lamp
You have now completed replacement of the limescale filter
Cleaning the appliance
♦
Clean the iron surfaces and the base station using only a soft, slightly moist
cloth.
♦
Clean the sole of the iron
the iron
♦
Pour the residual water in the water tank
iron down to one side and open the water tank filler cap
♦
The appliance must be completely dry before further use.
■
38
│ GB │ IE
.
upwards out of the limescale filter shaft.
in the limescale filter shaft and press it down
.
.
for about 3 seconds. The "anti calc" indicator
goes out.
with a soft moist cloth. Ensure that the sole of
is not scratched.
lights up.
from our service department (see
and allow it to cool
into a basin. To do this, put the
SDBS 2400 A1
.
.
Publicidad
