Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The machine continuously fills
with
water
and
continually
drains away
The discharged water flows
back into the appliance
The local part of the control
panel is heated
General
•
The top of the drain hose is too low – It must be fitted at a height between 65
and 100 cm from the floor (see "Installation").
•
The end of the drain hose has been pushed too far down the standpipe, the
hose elbow should be fitted 4' (100mm) from the end of the drain hose.
•
The end of the drain hose is submerged in the discharged water.
•
If the end of the drain hose touches the discharged water (water drained from
washer), it (the discharged water) can be sucked back into the appliance and
may damage the appliance or textiles.
•
This is the slight heating effect of the electronic components on the computer
board on the back of the control panel.
•
Your appliance contains sensors that monitor progress during the wash cycle
(eg: Water level, Temperature, Out of balance loads, Wash time/progress).
Normally, if your appliance successfully completes the cycle, there is unlikely
to be anything wrong!
118
Possible cause / solutions
Publicidad
