Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
• The appliance must be handled and
installed by two or more persons – risk of
injury. Use protective gloves to unpack and
install – risk of cuts.
• Keep children away from the installation
site.
• After unpacking the appliance, make sure
that it has not been damaged during
transport. In the event of problems, contact
the dealer or your nearest Technical
Assistance.
• During
installation,
appliance does not damage the power
cable – risk of fire or electric shock.
• When moving, do not lift the appliance by
the knobs or detergent drawer, without
lifting it by the worktop or top lid; during
transport, never rest the door on the trolley.
• The appliance is fitted with transport bolts
to prevent any possible damage to the
interior during transport. Before using the
machine, it is imperative that the transport
bolts are removed. After their removal,
cover the open transport bolt holes with the
four cover caps.
• The appliance must be installed and
operated in a room with the drain.
• Keep the environment dry and vented.
• Never put the machine over the opening of
an uncovered drainage.
• Do not install the appliance where it may
be exposed to extreme conditions, such as:
poor ventilation, temperatures below 5℃ or
above 35℃.
• Do not expose the appliance in the place
with causticity or explosibility gas. (e.g.
dust, steam and gas, etc.)
• Do not install the appliance in a bathroom
or a room very wet.
• The appliance should not be installed in an
outdoor environment, not even where the
area is sheltered, because it may be very
make
sure
the
dangerous to leave it exposed to damp,
rain and thunderstorms.
• When installing the appliance make sure
that the four feet are stable and resting on
the floor, adjusting them as required, and
check that the appliance is perfectly to level
using a spirit level.
• The appliance must not be installed behind
a lockable door, a sliding door or a door
with a hinge on the opposite side to that of
the appliance, in such way that a full
opening of the appliance door is restricted.
• The appliance must be disconnected from
the power supply before any installation
operation – risk of electric shock.
• Installation, including water supply (if any)
and electrical connections and repairs
must be carried out by a qualified
technician.
• Connect the water inlet hose(s) to the
water supply in accordance with the
regulations of your local water company.
• Use only the new water inlet hose(s)
supplied with the appliance to connect the
appliance to water supply. The old water
inlet hose(s) should not be reused.
• The supply water pressure must be in the
0.03—1.0 MPa range.
• Make sure that the ventilation openings in
the base of the appliance (if available on
your model) are not obstructed by a carpet
or other material.
• After installation of the appliance, wait a
few hours before starting it so that it
acclimates to the environmental conditions
of the room.
• Once installed, packaging waste (plastic,
Styrofoam parts etc.) must be stored out of
reach of children – risk of suffocation.
• Only activate the appliance when the
installation has been completed.
90
Publicidad
