Bosch 0603B01200 Manual Original página 32

OBJ_BUCH-880-001.book Page 31 Tuesday, March 24, 2009 4:39 PM
Minimal workpiece sizes
(= all workpieces that can be clamped left or
right from the saw blade with the supplied
quick-action clamp 14):
100 x 40 mm (length x width)
Cutting Off
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Adjust the requested horizontal and/or verti-
cal mitre/bevel angle.
– Switch on the machine.
– Press lever 3 and slowly guide the tool arm
downward by handle 1.
– Saw through the workpiece applying uniform
feed.
– Switch off the machine and wait until the
saw blade has come to a complete stop.
– Guide the tool arm slowly upward.
Replacing the Insert Plate
The red insert plate 7 can become worn after
long use of the power tool.
Replace defective insert plates.
– Bring the power tool into the working posi-
tion.
– Unscrew screws 8 using a Phillips screwdriv-
er and remove the old insert plate.
– Insert the new insert plate and and screw all
screws 8 in again.
Sawing Profile Strips
Profile strips/mouldings can be sawn in two dif-
ferent ways:
– Placed against the fence
– Lying flat on the saw ta-
ble
Always make trial cuts with the mitre angle set-
ting first on scrap wood.
Bosch Power Tools
Transport
– Bring the machine into the transport posi-
tion.
– For lifting or transporting, hold the power
tool by the recessed grips 13 on the side of
the saw table 11.
When transporting the power tool, use only
the transport devices and never use the
protective devices.
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
Cleaning
For safe and proper working, always keep the
power tool and its ventilation slots clean.
The retracting blade guard must always be able
to move freely and retract automatically. There-
fore, always keep the area around the retracting
blade guard clean.
Remove dust and chips after each working pro-
cedure by blowing out with compressed air or
with a brush.
Clean the roller 16 regularly.
1 609 929 S46 | (24.3.09)
English | 31