Cebora SPOT 2500 Manual De Instruccion página 14

4 GENERAL DESCRIPTION
4.1 Specifications
This machine was developed to handle the problems that arise in auto body repair
NOTE: Only steel bodies.
It makes it possible to eliminate dents or bulges on the body, working from just one side.
The welding machine must not be used for any other purpose, such as defrosting pipes or performing mechanical
tasks. The machine was designed to be used by the operator using the planned control devices
4.2 Explanation of the technical specifications listed on the machine plate
N°
IEC 62135-1
1
u20
I2cc
u1n
1-50/60hz
s50
IP23
S
NOTE : suitable for use in environments with a pollution rating of 3 (see IEC 60664-1)
4.3 Description of protective devices
4.3.1 Thermal protection
This machine is protected by a thermostat, which prevents the machine from operating if the allowable temperatures
are exceeded. In this condition the display will show the error code E1.
5 ASSEMBLY
Only skilled personnel should install the machine. All connections must be carried out according to current regula
tions, and in full observance of safety laws (regulation CEI 26-10 - CENELEC hd 427).
Place the welding machine in a stable and safe position. Air must circulate freely, both incoming and outgoing, and the
welding machine must be protected from entry by liquids, dirt, metal filings, etc.
♦
Make sure that the supply voltage matches the voltage indicated on the specifications plate of the welding
machine. When mounting a plug, make sure it has an adequate capacity, and that the yellow/green conductor
of the power supply cable is connected to the earth pin. The capacity of the overload cutout switch or fuses
installed in series with the power supply must be equivalent to the absorbed current I1 of the machine. Any
extension cords must be sized appropriately for the absorbed current I1
♦
Pacemaker wearers are prohibited from using the machine or approach the cables.
♦
Fully insert the earth cable plug into une socket (U or V) and turn clockwise
♦
Fully insert the gun plug into one socket (U or V) and turn clockwise.7
♦
Turn on the welding machine using the switch X on the back of the machine..
♦
To limit exposure to the magnetic field, keep the gun cable on the side of the hand holding it, avoiding wrap
ping the cable around.
14
Serial number, which must be indicated on any request regarding the welding machine
The welding machine is manufactured according to these international standards
Single-phase transformer
Secondary open-circuit voltage
Max. short circuit current
Rated supply voltage
Single-phase power supply
Power at 50%
Protection rating for the housing. Grade 3 as the second digit means that the equipment is
suit able for use outdoors in the rain
Suitable for use in high-risk environments
3300173/F 3301291