Publicidad
Idiomas disponibles
Idiomas disponibles
6
EQUIPMENT DESCRIPTION
A
Key to select the operator "USER"
B
LED. Signals the activation or shutdown of the operator selection function.
C
Key. Activates the pulse heating function. It is used to produce heat on thick sheet metal. It delivers
three consecutive pulses at a fixed interval of 360 msec. The buttons S and T adjust the power; display R
shows the setting. Minimum = 20 Maximum = 90.
D
LED. Signals activation of the pulse heating function. For operation, read "manual – automatic function"
LEd O.
E
LED. Signals activation of the rosette spot-welding function. For operation, read "manual – automatic
function" LEd O.
F
Key. Activates the rosette spot-welding function. Performs traction on sheet metal after first mounting
the hammer on the gun and fastening the three- pointed rosette to the hammer head. The power is constant.
Time is adjusted using the buttons S and T. The display R shows the setting: Minimum = 01 Maximum = 15.
G
LED. Signals activation of the insert spot-welding function. for operation, read "manual – automatic
function" LEd O.
H
Key. Activates the insert spot-welding function. fastens the various threaded inserts present in modern
auto bodies. The power is constant. Time is adjusted using the buttons S and T. The display R shows the
setting: Minimum = 01 Maximum = 50.
I
LED. Signals activation of the metal pressing function. for operation, read "manual – automatic function"
LEd O.
L
Key. Activates the sheet metal pressing function. serves to flatten sheet metal that has become
misshapen . It is carried out using the specific electrode. Time is fixed, and the buttons S and T adjust the
power; the display R shows the setting: Minimum = 20 Maximum = 60.
M
LED. Signals activation of the sheet metal heating function. for operation, read "manual – automatic
function" LEd O.
Key. Activates the sheet metal heating function.
N
unlimited. use the buttons S and T to set a power; the display R shows the setting. Minimum = 20 Maximum
= 60.
O
Automatic mode or manual selection key. Upon start-up, if the machine is set up for manual mode
"MAN" the LEd P lights.
NOTE: upon power source start-up the LEds flash, indicating "stand-by" status: the machine is on, with no
voltage, awaiting commands. Select an operating function.
Selecting between manual and automatic mode takes place by pressing the O key.
Manual mode means that, once the function is selected, spot-welding is controlled by the trigger; the LEd
that indicates the function choice remains lit without flashing, and the display R shows the setting.
Warning: in this operating mode the power source never enters "stand-by."
Automatic mode means that spot-welding is not controlled by the torch trigger. In relation to this the LEds
that show activation of the function have two operating modes:
1)
Flashing the machine does not deliver voltage. This means that it is waiting for the operator to
select a function, or that the machine has been inactive for more than two minutes. The display R shows
two lines ("stand-by").
NOT flashing the machine delivers reduced voltage, and to carry out the job set by the operator, it
2)
automatically makes sure there is contact between the torch and the workpiece. The display R shows the
setting numerically, and the keys T and S are active.
NOTE: In automatic mode, once a function is enabled, the machine generates a low voltage that serves
to check the contact between the gun and the workpiece; thus to correctly perform the job, proceed as
follows:
Rest the spot-welding electrode firmly and steadily on the workpiece.
Let the machine perform the job.
Lift up from the working position and do not rest the gun in zones that might accidentally come into contact
with earth.
P
LED which signals manual mode
Q
LED which signals automatic mode.
R
Display shows the settings made with the keys S and T.
3300173/F
3301291
heats deformed sheet metal using carbon. The time is
15
Publicidad
