HOMCOM 820-194V70 Manual De Instrucciones Y Montaje página 4

Flame brightness: It displays the current brightness of the flame, which ranges from one
to five positions.
Manual Operation
This is done by operating the switches located at the front of the fire. The right standby
rocker switch must first be switched on, the fire will beep to indicate that it is powered up.
Press the button once to turn on the appliance and fire effect. A red indicator light will
show to indicate that the fire is ON. Press the
dimmer mode, hold the button down until the desired brightness is obtained.
Press the button once for the low heat setting; press twice to switch off the heat
setting.
Press the button once for the high heat setting; press twice to switch off the heat
setting.
Remote Operation
The standby rocker switch located at the front right-hand side of the fire must first be
switched on; the fire will beep to indicate that it is powered up.
It takes a little time for the receiver to respond to the transmitter. Do not press the buttons
more than once within two seconds for the fire to operate normally.
1.Boot steps
1) Connect the power
2) Turn on the power switch
3) Press the control switch or "ON/OFF" key of the remote controller to start up
4) Press the 1000W button once for the low heat setting; press twice to switch off the heat
setting.
5) Press the 2000W button once for the high heat setting; press twice to switch off the heat
setting.
6) Press the DIMMER button to operate the dimmer mode, repeat pressing will raise and
lower the brightness.
2. Automatic heating
Press "IC" button on the remote controller to start or exit the automatic heating.
When turned on, the fireplace can automatically change the heating mode depending on
the set temperature and the room temperature.
During a timed starting process, it is possible to start heating ahead of schedule.
3. Setting the day and time
1) Settings are done on the remote controller
2) Press "DATE TIME" button, then press the "▲" or "▼" key to select the day
3) Press "DATE TIME" button again, then press the "+" or "-" to set the hour
4)Press "DATE TIME" button again, then press the "+" or "-" to set the minute
5) Press "OK" button to complete
4. Temperature setting
The default set temperature is 20℃, press "+" or "-" on the remote controller to set the
temperature, which ranges from 15 to 30℃. And this setting is only for the temperature in
the normally mode, not for the temperature in the timer mode.
NOTE: The set temperature must be higher than the room temperature for the heat
working.
button for 3 seconds this will operate the
4