Starting the engine (fig. 22):
Open fuel cock to "ON" position.
Turn "ON" the Ignition switch.
Put gear control in neutral position.
Pull out the choke knob (for cold engine start only).
Bring the throttle to idling position.
If you are starting engine for the first time in the day, press
the clutch lever and, keeping it pressed, kick the starter
pedal a couple of times.
For starting the engine press clutch lever and then press
the push button start switch.
When the engine is running normally, press the choke
knob back to its normal position.
Caution:
1.
Do not use electric starter for more than
5 seconds at a time. Release the push button
starts switch for approximately ten seconds before
pressing it again. If the engine fails to start after
repeated attempts hold the throttle 1/8-1/4 open
and push start switch.
2.
Before using the auto start switch ensure that you
press the clutch lever.
A
Open fuel cock
B
Switch on ignition
C
Put gear in neutral position
D
Pull the choke knob (with cold engine only)
E
Bring accelerator throttle to idling position
F
De-clutch
G
Kick starter pedal or push auto button (for auto
start).
69