Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND CARE OF DUST BAG
NOTE: An optional adapter and hose can connect the exhaust opening
directly to a shop-type vacuum cleaner.
An optional dust bag is available. To install the dust bag:
Disconnect the tool from the power source!
1.
Open the exhaust cover (A) Fig.
13, and clean out any sawdust.
2.
Insert the dust bag tube in
exhaust opening and push in
until seated.
3.
To remove, grasp the dust bag
tube where it enters the exhaust
opening and pull out.
4.
Unzip the bag and shake out
the sawdust. Occasionally turn
the bag inside out and brush
thoroughly.
To avoid personal injury from flying sawdust, keep the
exhaust cover closed when the nozzle is not installed. NEVER insert foreign
objects into exhaust opening.
TO ATTACH THE RIP GUIDE
An optional rip guide (Fig. 14) is available. To install:
Disconnect the tool from the power source!
1. Insert the rip guide through the
slot in the left side of the base,
over the stud, and through the slot
in the right side of the base.
2. Install the knob and washer on the
stud, and adjust the rip guide for
the desired width of cut, taking
into consideration the set of the
blade teeth.
3. Tighten the knob securely.
To avoid damage to the workpiece and possible personal
injury, extend the rip guide through both slots in base.
Fig. 13
Fig. 14
15
A
Publicidad
