Corghi 601 Manual De Uso página 58

SFA value; press the value "L"
original position, then repeat calibration.
3) In-1 value adjustment: this function can solve the separate reading (internal and ex-
ternal) problem. If a 100-g weight is positioned inside the tyre, the display shows 90 g
for the inside and 10 g for outside. This function can be used after self-calibration to
adjust the values stored in the In-I program.
value is the same as that used for the SFA value. Increase or decrease the In-1 value
according to the value measured for the inside (press the value "L" and
tons), if the value is greater than 110 g, decrease it and exit, then return to the original
position and perform self-calibration.
WARNING
Corghi is not to be held responsible for any claims deriving from the use of non-original
spare parts or accessories.
WARNING
Unplug the machine from the socket and make sure that all moving parts have been
locked before performing any adjustment or maintenance operation.
WARNING
Do not remove or modify any part of the machine (except for service interventions).
CAUTION
Keep the work area clean.
Never use compressed air and/or jets of water to remove dirt or residues from the
machine.
Take all possible measures to prevent dust from building up or raising during clean-
ing operations.
Keep the wheel balancer shaft, the securing ring nut, the centring cones and flange clean,
using a brush previously dripped in environmentally friendly solvents.
Handle cones and flanges carefully so as to avoid accidental dropping and subsequent
damage that would affect centring accuracy.
After use, store cones and flanges in a place where they are suitably protected from dust
and dirt.
If necessary, use ethyl alcohol to clean the display panel.
Perform the calibration procedure at least once every six months.
Check that the machine is correctly calibrated at the end of every month of use using the
58
and buttons. After adjusting, return to the
The procedure to retrieve the In-1
Operator's manual @ 601
but-