Install Battery - Rain Bird EASY RAIN Manual De Instrucciones

EASY RAIN™
Easy Rain™ is a battery-operated, single-valve controller that works
with Rain Bird DV, ASVF, PGA, PEB, PESB, GB, EFB-CP , BPE and
BPES valves. Easy Rain's maximum operating pressure is 150 psi
(10 Bars).

Install Battery

A
1. Water-seal the battery connector terminals by applying some
light grease (provided) to them. Then install a top-grade, 9-volt
alkaline battery.
2. Put the battery in the battery compartment with the terminals on
top. Tighten the lid to prevent water damage.
NOTE: Replace the battery once a year. To save the program, install
the new battery within 30 seconds of removing the old one. Do not
install the battery in damp conditions, or condensation may form
inside the battery case.
Set, Reset, or Change Program
B
To set, reset, or change the program, turn the programming dial to
RESET PGM and wait at least 10 seconds. Then follow steps C, D,
and E to set the program.
Select Start Time (in hours)
C
Turn the dial to choose the number of hours until the first watering
occurs. In the yellow band of the label, you can choose no delay
(+0), a 2-hour delay (+2), a 4-hour delay (+4), and so on, up to
a 12-hour delay (+12). For example, if you set the knob to RESET
2 Easy Rain™