Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 6
Lay the dresser face-down on a clean protected surface and measure from top left to bottom right and
6.
from top right to bottom left. If the unit is square, the measurements will be equal. If one is longer,
tap the bottom of a side panel until the measurements are equal. Lay the Backs (L) on the unit so that
the two pieces meet and can be fastened to the Top, the Sides, and Lower sleeper. Insert #6 x 5/8"
Philtruss Antique Brass Screws (ZG) through the predrilled holes in the back. See Figure 6.
Completely thread a Nylon Insert (ZE) on each Adjustable Glide (ZF) and firmly tap all the way into
the hole in bottom of both Side Panels. Turn the dresser right-side up and place it at its final destination.
Rotate the adjustable glides to level the unit.
B
P
D
A
Fig 7
Attach two Drawer Sides (B) to one of the Drawer False Fronts (C) with #8 x 1-1/4" Black Screws (P)
7.
through the predrilled holes in the sides. The grooves for the Drawer Bottom must line up. Slide the
Drawer Bottom (D) into the grooves. Attach the Drawer End (A) to the Sides in the same manner.
See Figure 7. Repeat for the other five drawers.
Square the drawers by measuring from left front to right rear and from right front to left rear. The
measurements should be equal. If not, hold the drawer by the corners on the longest line and squeeze
them together until it is square. See Figure 7a.
ZG
ZG
ZE
C
ZG
ZG
STAIN TEST AREA
ZF
B
P
P
Fig. 7a
L
ZE
ZF
586Wd — Page 7 — 03/14
Publicidad
