Vornado 1303 Guia Del Propietario página 5

GETTING STARTED
INSTALLING CIRCULATOR HEAD (Models 6803 & 7803 Only)
No tools required!
1. Gently place the circulator head face down on the ground on a
soft cloth to avoid scratches or damages to the unit. Insert power
cord into the top of pole (A) and pull through the bottom (B). Align
the Lock Release Button (C) on circulator head with the hole (D)
located on the pole. Push the pole onto the circulator head until
the Lock Release Button snaps into place.
B
Lock Release
Button
A
WARNING: Pinch Hazard between parts. Use caution
when assembling the stand.
8
English
STAND ASSEMBLY (Models 6803 & 7803 Only)
1. The upper pole and lower pole are pre-assembled, with the
fastening nut (E) secured on the underside of the base. Rotate
fastening nut counter- clockwise to remove.
2. The legs are designed to fit into the grooves (F) on the under-
side of the base cap. Assemble all the legs onto the pole, then
replace fastening nut by rotating clockwise to secure all the legs
in place.
F
CORD MANAGEMENT
1. Wrap cord around Air Accelerator, located on back of unit.
Secure cord with three clips (G) located at 2, 6 and 10 o'clock
positions.
E
ADJUSTING HEIGHT (Models 6803 and 7803 Only)
1. Before adjusting the height of the circulator, support the circu-
lator head with one hand. Use your other hand to loosen the
height adjustment collar by gently rotating it counter-clockwise.
2. Slowly raise or lower the pole to the desired height and secure
into position by rotating the adjustment collar clockwise until tight.
G
Air Accelerator
9
English