Vornado 1303 Guia Del Propietario página 6

CLEANING
GRILLE REMOVAL
Screwdriver required.
WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing grille.
Using a phillips head screwdriver, re-
move grille by unscrewing the 4 screws
located along the perimeter of the inlet
²
grille at roughly 2, 5, 7, and 11 o'clock
positions. This will release the grille. To
reattach, position grille so the logo in
the center of the grille is straight. Models
5303, 6303, 6803, 7503, 7803, align the
Locator Pin (A) to reconnect grille. Once
aligned replace screws.
Model 1303, align the Alignment Rib (B)
to reconnect grille. Once aligned replace
screws.
²
Use the brush attachment on your
household vacuum cleaner to
vacuum any accumulated dust off
the Front Grille and Air Inlets.
10 English
²
²
B
A
CLEANING
BLADE REMOVAL
Pliers recommended.
WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing blade.
1. First, remove the nut from the shaft
by turning the nut clockwise to
loosen. If included, remove washers
and set aside. Pull the blade straight
out from the shaft.
2. Wipe the Blade with a damp cloth.
If your circulator is used in a greasy
environment, such as a kitchen,
mild soap or a common household
cleaner may be necessary. Do not
use solvents. Do not place blade in
the dishwasher. The excessive heat
can distort the plastic.
3. To reattach - be certain the flat
side of the shaft aligns directly with
the corresponding flat side on the
blade's socket. Push the blade all
the way on the shaft until it bottoms
out. Do not use a hammer as this
could result in bearing damage.
If included, reinstall provided
washers and nut.
Remove the Nut
11
English