Makita HR2631F Manual De Instrucciones página 5

Lighting up the lamps
For Model HR2631F, HR2631FT
CAUTION:
• Do not look in the light or see the source of light
directly.
1
► 1. Lamp
To turn on the lamp, pull the trigger. Release the trigger to turn it off.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
• Do not use thinner or gasoline to clean the lamp.
Such solvents may damage it.
Reversing switch action
CAUTION:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
For Model HR2631F, HR2631FT, HR2630, HR2630T
CAUTION:
• If the switch trigger can not be depressed, check
to see that the reversing switch is fully set to
position (A side) or
► 1. Reversing switch lever
(B side).
B
A
1
This tool has a reversing switch to change the direc-
tion of rotation. Move the reversing switch lever
to the position (A side) for clockwise rotation or
the position (B side) for counterclockwise rotation.
For Model HR2641
A
► 1. Reversing switch lever
NOTE:
• When you operate the tool in counterclockwise
rotation, the switch trigger is pulled only halfway
and the tool runs at half speed. For counterclock-
wise rotation, you cannot push in the lock button.
This tool has a reversing switch to change the direc-
tion of rotation. Move the reversing switch lever to
the position (A side) for clockwise rotation or
the position (B side) for counterclockwise rotation.
Changing the quick change chuck
for SDS-plus
For Model HR2631FT, HR2630T
The quick change chuck for SDS-plus can be easily
exchanged for the quick change drill chuck.
Removing the quick change chuck
for SDS-plus
CAUTION:
• Before removing the quick change chuck for
SDS-plus, always remove the bit.
3
1
2
► 1. Quick change chuck for SDS-plus 2. Change
cover line 3. Change cover
5 ENGLISH
1
B