SCHOLTES TIS 621 CPT L Manual De Instrucciones página 15

To exit this mode, follow the procedure described above.
The display will show the text DE and OF and the hob will
be switched off. When it is next switched on, the hob will
function normally.
The EXTENSO TECHNOLOGY mode
The EXTENSO TECHNOLOGY
power of two „interconnected" hotplates to the same
level. It can be activated if the two hotplates are OFF,
by pressing the EXTENSO TECHNOLOGY
The EXTENSO TECHNOLOGY
while the hob is on by pressing the
TECHNOLOGY button once; the LEDs corresponding
to both linked hotplates light up.
The 2 LEDs remain lit as long as the hotplates are
linked (if EXTENSO TECHNOLOGY
again, the hotplates are disconnected and are both set
to power level 0).
Pressing the +, - or Max buttons for one of the two Flexi
hotplates also affects the display corresponding to the
other hotplate.
To deactivate the EXTENSO TECHNOLOGY
the button .
A timer may be set for the EXTENSO
this appears on the display and both LEDs
corresponding to the linked hotplates light up. When
the Timer button is pressed, the two linked hotplates
are treated as if they were a single zone.
Selecting and using EXTENSO TECHNOLOGY
To begin using the EXTENSO
the button. To set the power level (see above).
EXTENSO TECHNOLOGY
Once you have selected EXTENSO TECHNOLOGY
by pressing the button , the 2 LEDs corresponding
to the EXTENSO TECHNOLOGY
light up; it will then be possible to control both as if
they were a single zone. The power level will appear
on both displays. If only the upper or lower part is in
use, the display corresponding to the unused zone
will begin to fl ash, and after 3 minutes cooking will
automatically revert to standard mode
TECHNOLOGY).
! Once activated, the EXTENSO TECHNOLOGY
also be programmed, using the same procedure as
described for the individual hotplates.
can be used to set the
button
can be activated
EXTENSO
button is pressed
, press
TECHNOLOGY;
TECHNOLOGY, press
operation
for both hotplates
(notEXTENSO
can
! Accessories
For optimal EXTENSO TECHNOLOGY
we recommend the use of pans with an elliptical
or elongated base and a major diameter of at least
250 mm; if using pans with a smaller diameter, we
recommend positioning them in the upper or lower part
as indicated by the X symbol.
If the saucepan is not in the centre of the screen
printing detail, you may hear a whistling sound or
a slight buzzing noise; this does not indicate a hob
malfunction. We recommend adjusting the position
of the pan so that it is in the centre of the EXTENSO
TECHNOLOGY zone
GB
performance,
15