Oase InScenio FM-Master Cloud Puesta En Marcha página 18

Installation
WARNING
The unit is subject to dangerous voltage and must not be installed directly adjacent to the water.
Otherwise there is a risk of severe injuries or death by electrocution.
 Install the unit at a distance of at least 2 m from the water to ensure that it is protected
against flooding.
 A, B
Connection
Connecting an OASE Control-compatible unit
On OASE Control-network ...
• may consist of a max. 10 units.
• may be max. 100 m long.
OASE Control-Connection cables of the following lengths are available as accessories:
2.5 m (article number 47038), 5 m (47039), 10 m (47040) and 30 m (72713)
• must end at the last unit with the OASE Control-terminal resistor (R).

More information on OASE Control is available at www.oase.com in the "Smart garden con-
trols and lighting" section.
Connecting
NOTE
The OC connection must always be connected. Either through the plug of an OASE Control cable
or the OASE Control end resistor (R).
The unit will be damaged if water enters a connection.
 The rubber seal of the plug connector must be clean and must fit exactly.
If the rubber seal is damaged, it must be replaced. If the connection is disconnected, an older

rubber seal (> 2 years) must be replaced.
Always secure the plug connection with 2 screws.

 C
18