Publicidad
Idiomas disponibles
Idiomas disponibles
7.1 Programming of servings: espresso coffee and hot water
1)
Turn the knob 1 of the main switch to position 0 (zero).
2)
Press key G (continuous serving of first serving group) and while holding it down, turn the knob of the
main switch to position 2. Release key G; the machine will enter programming. Push button G and the
same key of all groups will flash.
Programme the espresso coffee servings using keys A, B, C, D, E, F:
3)
Prepare the machine to dispense a single or a double coffee based on the serving to be programmed.
Place the cups under the serving spout.
4)
Press once on the key for the serving to be programmed. Once the desired amount of coffee has been
reached, stop serving by pressing once on push button G.
5)
Repeat steps 3 and 4 for all of the keypads. If you want to programme the servings for all of the other
groups by copying the servings programmed on the first keypad, press once on the continuous serving
key for each serving group. The LED in the keys will remain on.
Programming of amounts of hot water using keys H, I:
6)
Press once on key H (small tea) and dispense hot water. Press once on button L (continuous serving)
when the desired amount is reached.
7)
Programme in the same way the amount for push button I (large tea).
8)
Upon completion of programming, press once on key G (continuous serving of first group) to save the
settings. The espresso coffee machine is now ready for use.
8. Routine maintenance
routine maintenance.
coffee machine; use water and neutral detergents.
8.1 Cleaning the serving units and the filter holder
1)
Detach the filter cup from the serving unit, remove the coffee grounds and replace the filter present with
the blind filter (without holes) provided with the machine.
2)
Using the brush, clean the seat in the unit in which the filter cup is inserted.
3)
Insert the cup in the unit and, without latching it completely, press the continuous flow button.
4)
Let water overflow from the filter holder. This will clean the serving group.
The continuous flow of water from the unit can cause burns due to accidental skin contacts.
5)
Stop the water flow and insert the filter cup in the unit.
6)
Start the continuous flow and then stop it after a couple of seconds; repeat this operation a few times
(this is to clean the drain duct and the solenoid of the unit).
38
3
-
-
Publicidad
