Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
APPLICATIONS
Planing various wooden planks and panels
Fig. 4-A (Planing)
23/64"(Max)
(9mm)
Fig. 4-D (Tapering)
REMOVAL AND INSTALLATION METHOD
OF BATTERY
How to install the battery.
Align the battery with the groove in tool handle
and slip it into place.
Always insert it all the way until it locks in place
with a little click, If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you (Fig. 5).
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch (2 pcs) of the battery (Fig. 5).
Pull out
Insert
Battery
12
ASSEMBLY AND OPERATION
Fig. 4-B (Beveling)
Handle
Latch
Push
Fig. 5
Fig. 4-E (Side planing of flush door)
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1.
Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
WARNING
Do not use the electrical cord if
damaged. Have it repaired
immediately.
23/64"(Max)
(9mm)
Fig. 4-C (Rabbeting)
Side face cutting
Publicidad
Tabla de contenido
