Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
(3) As shown in Fig. 18, fix the bolts at the blade holder
after blade replacement has been completed.
(4) Turn the cutter block over, and set the other side in
the same manner.
3. Adjustment of carbide blade height
CAUTION
If the carbide blade's heights are inaccurate after
above procedures have been completed, carry out
the procedures described below.
(1) As shown in Fig. 19, use the box wrench to loosen
the three bolts used to retain the carbide blade, and
remove the blade holder.
Blade holder
(2) As shown in Fig. 20, after removing the carbide
blade, slide set plate (B) in the direction indicated
by the arrow to disassemble set plate (B).
(3) Loosen the 2 screws holding on the carbide blade
and set plate (A), set plate (B).
(4) As shown in Fig. 21, 22, press the turned surface of
set plate (A) to the wall surface b while adjusting
the carbide blade edge to the wall surface a of the
set gauge. Then, tighten them with the 2 screws.
Fig. 18
Box wrench
Bolt
Fig. 19
Set plate (B)
Fig. 20
Machine screw
Set plate (B)
Set plate (A)
Turned surface
Wall surface b
(5) As shown in Fig. 23, 24, insert a turned portion of
set plate (A) attached to set plate (B) into a groove
on the flat portion of the cutter block.
Flat portion of the cutter block
Groove
(6) As shown in Fig. 25, place the blade holder on the
completed assembly and fasten it with the three
bolts. Ensure that the bolts are securely tightened.
Follow the same procedures for the opposite side
carbide blade.
English
Fig. 21
Carbide blade
(Double edged
blade type)
Set gauge
Wall surface a
Fig. 22
Set plate (A)
Fig. 23
Fig. 24
17
Publicidad
Tabla de contenido
