Panel Dust Filter Cleaning And Integrity Check - Advance SW4000 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PANEL DUST FILTER CLEANING AND INTEGRITY CHECK

The dust ilter must be regularly cleaned to maintain the
eficiency of the vacuum system. Follow the recommended ilter
service intervals for the longest ilter life.
WARNING!
Wear safety glasses when cleaning the ilter.
Do not puncture the ilter.
Clean the ilter in a well-ventilated area.
Wear appropriate dust mask to avoid
breathing in dust.
1.
Drive the machine on a level ground, engage the parking
brake and turn the ignition key (61) to "0".
2.
Open the battery compartment hood (18) with the handle
(41) and fasten it with the support rod (52), then disconnect
the battery connector (45).
3.
Disconnect the vacuum system motor connector (53).
4.
Release the fasteners (A, Fig. 13) and remove the vacuum
system cover (B).
Unscrew the knobs (C, Fig. 14) and remove the ilter
5.
shaker assembly (D).
Fasten the ilter shaker assembly to the holder (E).
6.
Lift the dust ilter (F) and remove it from the machine.
7.
Clean the ilter using one of the methods below:
8.
Method "A"
Collect dust from the ilter. Gently tap the ilter against a lat
surface (with the dirty side down) to remove dust and dirt.
NOTE
Take care not to damage the metal lip which extends
past the gasket.
Method "B"
Collect dust from the ilter. Blow compressed air (maximum
pressure 6 Bar) into the clean side of the ilter (in the opposite
direction of the airlow).
Method "C" (only for polyester dust ilter)
CAUTION!
For paper ilter: Do not use water or detergents to
clean it, otherwise it can be damaged.
Collect dust from the ilter. Then soak the ilter in warm water
for 15 minutes, then rinse it under a gentle stream of water
(maximum pressure 2.5 Bar). Let the ilter dry completely before
installing it back into the machine.
For a better cleaning, it is allowed to wash the ilter with water
and non-lathering detergents.
This provides better quality cleaning but reduces the life of the
ilter, which will have to be replaced more frequently. The use of
inadequate detergents can damage the ilter.
Install the ilter in the reverse order of removal and note the
9.
following:
Clean the ilter housing.
Install the ilter with the strainer facing upwards (arrow
(G. Fig. 14) upwards).
If the ilter gasket is damaged or missing, it must be
replaced.
INSTRUCTIONS FOR USE
A
B
A
Figure 13
D
C
C
F
Figure 14
1464818000 - SW4000
ENGLISH
A
A
P100600
C
E
G
C
P100601
27

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

9084403010

Tabla de contenido