Parkside PADM 1250 A1 Traduccion Del Manual De Instrucciones Originale página 25

Technical data
Planer Thicknesser ............ PADM 1250 A1
Nominal input voltage U ... 230 V~; 50 Hz
Power input P ........................... 1250 W
Idling speed of the blade shaft
n .......................................8500 min
0
Weight m ..................................... 21 kg
Planer width ...................... max. 204 mm
Max. chip removal ......................... 2 mm
Vibration level
(a ) ................ < 2.5 m/s
h
Thicknesser
Passage height/width ...... 120/204 mm
Feed rate ............................6.3 m/min
Protection type .................................IPX0
Sound pressure level
(L ) ....................... 90.0 dB; K
pA
Sound power level (L
measured .............. 97.5 dB; K
Surface planer
Sound pressure level
(L ) ....................... 98.8 dB; K
pA
Sound power level (L
measured ............ 107.2 dB; K
Levels of noise and vibration were deter-
mined according to the standards and reg-
ulations in the declaration of conformity.
The vibration emission value has been
measured according to a standardised
testing method and may be used for com-
parison with another power tool.
The indicated vibration emission value may
also be used for an introductory assess-
ment of the exposure.
Warning: The vibration emission
value whilst actually using the pow-
er tool may vary from the given values de-
pending on the type and way in which the
power tool is used.
Try to keep the exposure to vibrations as
; K= 1.5 m/s
2
= 3 dB
pA
)
WA
= 3 dB
WA
= 3 dB
pA
)
WA
= 3 dB
WA
low as possible. An example of a measure
to reduce vibration exposure is limiting the
working hours. All parts of the operating
cycle have to be considered while doing
so (for example, times when the power tool
is switched off and times when it is
-1 switched on but running without any load).
Safety information
CAUTION! The following basic safe-
ty precautions must be observed
2
while using power tools to protect against
electric shock, injury and risk of fire.
Please read all instructions before using
this power tool and keep the safety instruc-
tions in a safe place.
Graphical symbols
Symbols on the device:
Read the instruction manual!
Wear ear protection
Wear eye protection
Wear respiratory protection
Wear safety gloves
Do not reach into the running blade
shaft
Remove the plug from the mains
socket before carrying out
maintenance and repair work.
Electrical devices must not be dis-
posed of with domestic waste.
Blade shaft direction of
rotation
GB MT
25