Parkside PADM 1250 A1 Traduccion Del Manual De Instrucciones Originale página 31

external dust extraction cannot be con-
nected to the collection container (16)
due to its diameter.
To dismantle, loosen the two small
screws (22). Then pull the latches (21) out
of the recesses (13) on the right and left of
the discharge table (14) and remove the
collection container (16).
Checks before putting
into operation
Before putting into operation, check:
- the planer blade
- the anti-kickback claws
- the functioning of the On/Off switch
- the blade brake
If any of these checks reveal damage or
improper operation, do not operate the
machine.
Before first use, remove the rubber
band attached to the anti-kickback
claws.
Checking the switch and
blade brake
On/Off switch
1. Turn the machine on using the On switch
(9) and allow it to reach full speed.
2. Turn the machine off using the Off switch
(10). The blade must come to a standstill
within 3.5 seconds. If this is not the case,
please contact the service centre.
Checking the anti-
kickback claws
Carry out a visual inspection of the an-
ti-kickback claws (24). The anti-kickback
claws must not have any visible defects
and they must all hang evenly in a row.
Do not operate the machine if the anti-kick-
back claws are damaged. Contact the
service centre.
1. Set the planing table (23) to the lowest
position.
2. Perform the visual inspection.
General working
instructions
• Secure a long workpiece from tipping by
using a roller table or roller block. There
must be one support in front of the feed
table and one behind the discharge ta-
ble. The height of the support must be set
so that the workpiece rests horizontally
on the feed table and can be carried
horizontally from the discharge table.
• Do not machine splintering material or
material which may have hidden metal
parts. Splintering material can cause
injury to the user. Metal parts that come
into contact with the blade can cause
the workpiece to break apart, which
can also lead to injuries.
• Wood that has lots of knots and knot-
holes can also cause the workpiece to
break apart. Do not machine this wood.
• Do not stand directly in front of the ma-
chine during operation and stand on
one side.
• If the blade shaft blocks during opera-
tion, switch off the machine and discon-
nect the mains plug.
Remove the workpiece and make sure
that the blade shaft can run freely again.
Application and storage of
the push stick
• Use the push stick when machining
small/short workpieces.
GB MT
31