Dirt Devil DD2501 Manual De Instrucciones página 5

HOW TO INSTALL / OPERATE THE MACHINE
Before you start
Always switch off and unplug the vacuum cleaner before
•
connecting or disconnecting the hose/attachments, or
removing and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for
any reason the vacuum cleaner does overheat the thermostat
will automatically turn the vacuum cleaner off. If this happens,
switch the vacuum cleaner off and unplug from electrical
socket. Remove and empty the dirt container and also check
the vacuum cleaner for blockages. Allow the vacuum cleaner
to cool for approximately 1 hour (if you have cleaned the filters
please wait 24 hours for the filters to fully dry before putting back
into the vacuum).
• Pre-motor filter requires cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch off and unplug before
removing the blockage.
When using the accessories always make sure the brush bar is
•
switched to the off position.
IMPORTANT: The base of the vacuum cleaner should
always be positioned flat on the floor when starting and
in use. The dirt container should be locked into place
before lifting the vacuum cleaner by the carry handle.
ASSEMBLING YOUR MACHINE
IMPORTANT: The condition of the filters affects the
performance of your machine. Please check and clean filters
periodically (depending on the level of use).
1. Insert the end of the hose into the unit. Ensure the hose has
clicked into place.