Publicidad
Idiomas disponibles
Idiomas disponibles
INITIAL INSTALLATION
5. Remove motor screws/lock washers (S) from
underside of motor housing (E). [Save motor
screws/lock washers (S) for later use.]
Note: Make sure to keep loose hardware
separate to avoid confusion during installation.
6a.
Remove vice from preassembled safety cable by
loosening preassembled screw and nut on vice.
6b.
Remove pin (J) and clip (K) from downrod (A).
Partially loosen preassembled set screws and nut
6c.
in motor housing yoke at top of motor housing (E).
5
6a
6b
K
E
8
S
E
Safety Cable
Vice
Nut
6c
A
J
Set Screw
Yoke
Screw
Publicidad
