cecotec BOLERO SQUAD I 2100 Manual De Instrucciones página 86

ENGLISH
3. INSTALLATION
Selection of the installation tools
Cut out the worktop according to the dimensions shown in the figure. (Fig. 3)
-
For its installation and use, you must keep a space of at least 5 cm around the gap.
-
Place a towel or cloth on the worktop surface and place the induction hob face down on
-
it.
Place the sealing tape supplied with the induction hob to seal it on the worktop surface.
-
Figure 4
6. Rear of the plate
7. Glass Surface
8. Towel or cloth
9. Tape
10. Self-adhesive tape
Do not use silicone. Apply the tape to the edge of the bottom of the induction hob, leaving
-
about 3 mm from the edge of the glass. Apply the tape all around the perimeter.
Cut off the excess and join the two ends of the tape to match.
-
Warning
The worktop material should be impregnated wood or other insulating material.
-
In any case, make sure the hob is well ventilated and the air inlet and outlet are not
-
blocked. Make sure the induction hob works correctly, as shown below.
Please note
The safety distance between the hob and a cabinet over the hob must be at least 760 mm.
A (mm)
760
Before installing the induction hob, make sure that:
The worktop is level and square-shaped, and no structural elements violate the space
-
requirements.
- The worktop material is heat resistant.
If you install the cooking hob over an oven, the latter must have a cooling fan.
-
The installation will comply with all the safety requirements, and the applicable rules and
-
regulations.
The hob incorporates a safety switch that allows it to be completely disconnected from
-
86
BOLERO SQUAD I 2100
Amplitude (mm)
Min. 50
C (mm) D
Min. 20 Air inlet
E
Air outlet 5 mm