ALLIGN AND TIGHTEN THE BELT OF THE TREADMILL / CENTRAR Y TENSAR LA BANDA DE LA CINTA DE CORRER / CENTRER ET
TENDRE LA BANDE DU TAPIS DE COURSE / CENTRARE E TENDERE IL NASTRO DEL TAPIS ROULANT / LAUFMATTE VOM
LAUFBAND ZENTRIEREN UND SPANNEN / CENTREREN EN AANSPANNEN VAN DE LOOPBAND / CENTRAR E ESTICAR A CINTA
DO TAPETE ROLANTE
(ENGLISH) REGULAR MAINTENANCE OF THE TREADMILL
STORAGE: Keep your equipment in a enclosed place, away from dust or humidity. Don't store it neither in a garage or in a
indoor backyard, or near the water. Humidity, dust and water could damage it and have an effect on its functioning
ELECTRIC CABLE: Make sure that the cable and plug are in perfect conditions. Electric cables must be away from hot
surfaces
SCREWS AND CONNECTING CABLES: Supervise and tighten the screws on a regular basis, because due to the vibration the
screws and nuts tend to loosen.
LUBRICATION: It's a correct lubrication of the treadmill with silicon oil or teflon is really important. This lubrication must be
performed regularly depending on its use even before the first use.The lubrication must be carried out this way: disconnect
the equipment of the electricity supply (in case you have one), pull up the tapestry from the side with one hand and spread
the oil on the board. Please repeat this procedure from the other lateral side. Connect the equipment to the power supply
(in case you have one) und turn the „on" button (red button) into the correct position (I), insert the security key and let the
treadmill work for several minutes without any weight on it. Repeat this action on a regular basis.
ALLIGN AND TIGHTEN THE BELT OF THE TREADMILL
o
ALLIGN THE BELT: UNPLUG THE UNIT FROM THE POWER SOURCE: UNPLUG THE POWER CORD: Due to its use,
the belt can move off centre. If the belt has moved to the left, use the hex key to turn the fixed left bolt
counterclockwise. Don't tighten the belt too much in order to be able to walk. Plug the power cord, insert the key
and let the treadmill work for a few minutes. Repeat this procedure until the belt is properly aligned.
o
TIGHTEN THE BELT: (if the belt slips on the treadmill when walking). UNPLUG THE POWER CORD: Using the hex
key, turn both bolts 1/4 clockwise. If the belt is properly tight to walk, you must be able to pull up each side of the
belt 5 or 7 cm off the platform. Be careful and maintain the belt aligned. Now plug the power cord, insert the key
and walk on the treadmill a few minutes. Repeat this procedure until the belt is properly tightened.
CLEANING: Don't use abrasive products. A damp cloth is enough.
LEVELING: If your unit is provided with levelling wheels, please adjust them in order to avoid vibrations and therefore
malfunctions.
KEEP THESE MAINTENANCE ADVISES FOR FUTURE REFERENCES
All manuals and user guides at all-guides.com
FYTTER |WWW.FYTTER.COM
PAG- 32