Cameo ZENIT B200 Manual De Usuario página 12

SLAVE MODE CONFIGURATION
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "Slave" (observe arrow) and confirm
with ENTER. Connect the slave and the master units (same model) with a DMX cable and enable one of the standalone modes on the master
unit (Auto, Colour Macro, Static, Tunable White, User Colour). Now the slave unit will follow the master unit. If there is no control signal, the
display characters will flash. Flashing stops as soon as a control signal is present.
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
Timer
DEVICE SETTINGS (Settings)
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "Settings" (observe arrow) and confirm
with ENTER.
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the following submenu items (see table, select with UP and DOWN, confirm with ENTER,
change value or status with UP and DOWN, confirm with ENTER):
Settings
Runtime =
Wireless Setting =
Display Reverse =
Display Backlight =
12
Mode
Slave
Increase battery life by up to
24 hours with correspond-
ingly reduced brightness
(calculated on full with 100%
battery)
W-DMX settings (Wire-
less-DMX)
Flip display
Display lighting
Off Function deactivated
4 hours - 24 hours Configure battery run time from 4 hours to 24
hours in 1 hour increments.
W-DMX On/Off On = W-DMX enabled
Off = W-DMX disabled
Operating Mode Receive = W-DMX module as receiver
Receive = W-DMX module as sender
Transmitting Mode G3 = G3 broadcasting standard
G4S = G4S broadcasting standard
Link Link = pair with W-DMX units. W-DMX must be
enabled on all devices, and the pairing with a
transmitter be retained (Receive Reset).
Unlink = decoupling of all devices
Receive Reset No = Do not retain transmitter pairing
Yes = Retain transmitter pairing
On Rotate display by 180° (e.g. for overhead
installation)
Off No display rotation
On On permanently
Off Deactivation after approximately 1 minute of
inactivity