PowerWalker LiFe Battery System 48-100 Manual De Instrucciones página 17

3.2 Mounting the Modules
Step 1: Clip two SNAP bushings into the stand feet. Then, fix two
fixing plates on the stand feed (both sides) with eight screws. Finally,
fix two L-type brackets on the battery module (both sides) with four
screws.
Step 2: Install one battery module by following below steps.
(a) Use a Ø 13 mm drill to drill holes about 60 mm deep according to
the distance indicated on the below chart. Drill two holes on the
612 . 5 mm
420 . 00 mm
Wall
612 . 5 mm
410 . 00 mm
85 . 00 mm
85 . 00 mm
583 . 00 mm
Floor
14