Philips sonicare 3000 Serie Manual Del Usuario página 16

16
English
Cleaning
Toothbrush handle
Brush head
- Triple tone of low-med-high means the pressure
sensor feature has been activated. The battery level
indicator light will also blink green 2 times to confirm
activation.
- Triple tone of high-med-low means the pressure
sensor feature has been deactivated. The battery level
indicator light will blink amber 1 time to confirm
deactivation.
If you continue holding the power on/off button after
the three short beeps, the activate/deactivate sequence
repeats.
You should clean your Philips Sonicare toothbrush
regularly to remove toothpaste and other residue. Failure
to clean your Philips Sonicare toothbrush may result in an
unhygienic product and damage to it may occur.
Warning: Do not clean product or accessories with
sharp objects or in dishwasher, microwave, with
chemicals or in boiling hot water
1 Remove the brush head and rinse the metal shaft area
with warm water. Make sure you remove any residual
toothpaste.
Caution: Do not push on the rubber seal on the metal
shaft with sharp objects, as this may cause damage.
2 Wipe the entire surface of the handle with a damp
cloth.
Note: Do not tap the handle on the sink to remove excess
water.
1 Rinse the brush head and bristles after each use.
2 Remove the brush head from the handle and rinse the
brush head connection with warm water at least once
a week. Rinse the travel cap as often as needed.