Philips sonicare 3000 Serie Manual Del Usuario página 19

2 Remove and discard the brush head. Cover the entire
3 Hold the top of the handle with one hand and strike
1
2
4 Remove the end cap from the toothbrush handle. If
5 Holding the handle upside down, press the shaft
6 Wedge the screwdriver between the battery and the
7 Insert the screwdriver between the bottom of the
handle with a towel or cloth.
the handle housing 0.5 inch above the bottom end.
Strike firmly with a hammer on all 4 sides to eject the
end cap.
Note: You may have to hit on the end several times to
break the internal snap connections.
the end cap does not release easily from the housing,
repeat step 3 until the end cap is released.
down on a hard surface. If the internal components
do not easily release from the housing, repeat step 3
until the internal components are released.
white frame at the bottom of the internal
components. Then pry the screwdriver away from the
battery to break the bottom of the white frame.
battery and the white frame to break the metal tab
connecting the battery to the green printed circuit
board. This will release the bottom end of the battery
from the frame.
19
English