Descargar Imprimir esta página

Silvercrest SEMD 12 A1 Instrucciones De Uso página 39

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Making ice cream
CAUTION! MATERIAL DAMAGE!
Start the appliance fi rst and then add ingre-
dients. Otherwise the ice mixture will freeze
onto the sides of the beaker 8 and block the
ice scrapers 7. This will cause the motor to
overheat!
CAUTION! MATERIAL DAMAGE!
GB
Do not stop the appliance during processing!
MT
Otherwise the ice mixture will freeze onto
the sides of the beaker 8 and block the ice
scrapers 7 when the machine is restarted.
This will cause the motor to overheat!
1) Remove the beakers 8 from the freezer and
put the appliance together as described in the
section "Assembly".
2) Switch the appliance on by moving the On/
Off switch 1 to the position I. The two ice
scrapers 7 start turning.
3) Now fi ll the prepared ice mixture into the beak-
ers 8 through the fi lling openings 4. Ideally,
use a bowl with a spout. Never add more than
300 ml per beaker 8. During processing the
mixture increases in volume!
NOTE
You can also fi ll only one beaker 8 with
ingredients. However, always use the appli-
ance with both beakers.
36
NOTE
The ice scrapers 7 may occasionally change
their direction of rotation. This happens when
the mixture becomes too stiff . This is normal
and not an appliance defect.
4) Allow the appliance to continue running until
you are satisfi ed with the consistency of the
mixture. After a maximum of 20 to 30 minutes,
the ice cream is ready.
5) Switch the appliance off at the On/Off switch 1
and pull the mains power plug out of the socket.
6) Turn the rotary switch 9 to
lid 5 with the motor unit 2.
7) Pull the ice scrapers 7 out of the ice cream.
If the ice cream sticks to them, scrape it off with
a plastic spoon or similar.
8) Lift the beakers 8 out of the appliance and
remove the ice cream. Use only plastic or
wooden implements to do this.
CAUTION! MATERIAL DAMAGE!
Do not use metal utensils to remove the ice
cream from the beakers 8.
NOTE
If you would like to replace the lid 5 on
the beakers, you must fi rst detach the motor
unit 2 from the lid 5. Then proceed as de-
scribed in the section "Assembly". Otherwise,
it is possible that the drive shafts 3 do not
slide correctly into the drive shaft socket 6.
to remove the
SEMD 12 A1

Publicidad

loading