Parkside PLSA 20-Li A1 Traduccion Del Manual De Instrucciones Originale página 19

Inserting the 12 V battery
1. Slide the battery (12) into the 12 V
adapter (8).
Removing the 12 V battery
1. Press the release buttons (11) on the bat-
tery (12).
2. Pull the battery (12) up and out of the
12 V adapter (8).
Removing the 12 V adapter
1. Pull the latch (7) on the bottom of the
12 V adapter (8) towards you.
2. Pull the 12 V adapter up and out.
3. For storage, you can slide the 12 V ad-
apter (8) onto the guide (14) on the side
of the device.
Switching on/off
1. To switch the device on, press the
On/Off switch (2). The LED lamp illumi-
nates with maximum brightness.
2. To switch the device off, press the
On/Off switch (2).
Changing the
illumination mode
When you switch the device on, the LED
lamp illuminates with maximum brightness.
Switch the illumination mode by pressing
the switch (1) next to the On/Off switch
(2).
The repeating order of modes is: 2000 lm -
1000 lm - fl ashing
Working instructions
Do not stare into the battery-powe-
red LED fl ood lamp while it is on.
Swivelling the battery-
powered LED fl ood lamp
1. Loosen the adjusting screw (4).
2. Rotate the handle (3) of the battery-
powered LED fl ood lamp to the desired
position.
3. Tighten the adjusting screw (4).
Hanging the battery-
powered LED fl ood lamp
Hanging the battery-powered
LED fl ood lamp on the hook
1. Fold the hook (5) outwards.
2. Hang the device horizontally.
Hanging the battery-powered
LED fl ood lamp using the key-
hole bore
1. Insert a screw or nail at the desired po-
sition on a wall.
2. The screw/nail head can have a dia-
meter of 7 - 10 mm.
3. Leave the screw/nail head protruding
at a distance of approx. 10 mm from
the wall.
4. Hang the device on the keyhole bore
(15).
Hanging the battery-powered
LED fl ood lamp on the base-
plate
1. Insert a screw or nail at the desired po-
sition on a wall.
2. The screw/nail head can have a dia-
meter of 7 - 10 mm.
3. Leave the screw/nail head protruding
at a distance of approx. 10 mm from
the wall.
4. Hang the device via the recess (6) on
the baseplate with teeth. The teeth al-
low you to balance the device.
GB IE
19