Ravelli VELA 7 Serie Manual De Uso Y Mantenimiento página 70

AL 04 FUME Fume exhaust encoder is not working or is
EXHAUST connected incorrectly
DAMAGED
No power to fume extractor.
The fume extractor is blocked.
AL 05 NO SWITCH- The pellet tank is empty.
ON
Pellet calibration and suction during switch on
phase
is incorrect.
The ignition coil is faulty or positioned
incorrectly
AL 06 PELLETS The pellet tank is empty.
FINISHED
The gear motor is not loading pellets.
Not enough pellets loaded
AL 07 RESETTABLE The manual reset thermostat connected to the
THERMAL hopper has been triggered
BREAKER
Combustion in the brazier is not optimal due to
clogging or obstructions of internal stove ducts
inside the stove
AL 08 DEPRESSION The flue is blocked.
The vacuum meter is faulty.
AL 12 FUME The fume exhaust system has a loss of
EXHAUST performance due to fan obstruction or voltage
SYSTEM drop.
AL 14 SCREW No cable connection to power the gear motor
PHASE screw
AL 15 SCREW TRIAC An internal part of the electronic board that
controls the pellet infeed screw is faulty.
Possible voltage drops or incorrect input
voltage
AL 19 CLEANER The cleaner did not complete the movement
FAILURE and is not in the correct position
Position of the switch,
protected by the screw cap, for
the safety reset thermostat on
the back of the stove.
Use and maintenance manual Vela 7-9
Contact the Support Service
Contact the Support Service
Contact the Support Service
Check for the presence of pellets in the container.
Top up, if necessary.
Contact the Support Service
Contact the Support Service
Check for the presence of pellets in the container.
Top up, if necessary.
Empty the tank to see if there are any objects inside
that may prevent proper operation of the auger.
Regulate pellets setting from "SET AIR/PELLETS"
If the problem persists, contact the Support Service
Reset the thermostat by pressing the button on the
back of the stove
Switch off the stove, clean the brazier and the tube
bundle and adjust the combustion setting the Pellet/
Air values
Contacter le Service d'Assistance
Check the flue is free and clean
Check the mains voltage.
Check the mains voltage.
Check the mains voltage.
Check the flue is free and clean
Check the mains voltage.
Reset the alarm and wait for the stove to switch to
SHUTDOWN mode. Cut off and power again, the
system reactivates the cleaner searching the correct
position again.
If the problem persists, contact the Support Service
Rev.1 20.02.18
Page 71
EN