Powerworks PD24D90 Manual Del Operario página 6

EN
1 DESCRIPTION
1.1 INTENDED USE
The machine is used to:
• drilling in all types of wood products (lumber,
plywood, paneling, composition board, and hard
board)
• drilling in ceramics, plastics, fiberglass, and
laminates
• drilling in metals
• driving screws into wood and drywall with
screwdriver bits
1.2 OVERVIEW
Figure 1
1 Two-speed gear
button ( HI-LO)
2 Auxiliary handle
3 Torque adjustment
ring
4 Keyless chuck
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow all instructions listed below may result
in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
3 INSTALLATION
3.1 INSTALL THE BELT CLIP
Figure 2
The belt clip may be installed on either side of the
housing.
1. Align the belt clip with the hole on the machine.
2. Insert and tighten the screw to secure the belt clip.
3.2 ATTACH THE AUXILIARY HANDLE
Figure 3-4
The auxiliary handle may be installed on either side of
the machine.
English (Original Instructions)
5 LED light
6 Trigger
7 Directon button
8 Belt clip
WARNING
NOTE
1. Turn the handle grip counter-clockwise to loosen it.
2. Open the hooks wide enough to fit over the
mounting ribs, behind the mode selection ring.
3. Place the hooks over the mounting ribs, making
sure the hooks are positioned in the slots as shown.
4. Turn the handle grip clockwise to tighten.
Make sure the handle is secure before beginning
operation.
3.3 INSTALL THE BIT
Figure 5-6
1. Push direction button in the center position to lock
the trigger.
2. Turn the chuck counter-clockwise to open.
3. Tilt the machine upwards to keep the bit from falling
out.
4. Put the bit into the opening of the chuck.
5. Make sure that the bit is centered, then turn the
chuck clockwise to tighten.
Do not use a wrench to tighten or loosen the chuck
jaws.
WARNING
Put the bit straight into the chuck. Do not put the bit
into the chuck at an angle then tighten.
3.4 REMOVE THE BIT
Figure 7
1. Push direction button in the center position to lock
the trigger.
2. Turn the chuck counter-clockwise to open.
3. Remove the drill bit.
WARNING
Be prepared for binding at bit breakthrough. When
these situations occur, drill has a tendency to grab
and kick opposite to the direction of rotation and
could cause loss of control when breaking through
material. If not prepared, this loss of control can result
in possible serious injury.
3.5 INSTALL THE BATTERY PACK
Figure 8
4
CAUTION
NOTE