Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4.5
STOP THE MACHINE
1. Release the trigger to turn the machine OFF.
Release the trigger and allow the machine to come to
a complete stop.
4.6
ADJUST THE VARIABLE SPEED
Figure 12
1. Increase the trigger pressure to make a higher
speed.
2. Decrease the trigger pressure to make a lower
speed.
4.7
DRILL MATERIALS
•
When drilling hard, smooth surfaces, use a center
punch to mark the desired hole location. This can
prevent the drill bit from slipping off-center when
drilling is started.
•
When drilling metals, use a light oil on the drill bit to
prevent it from overheating. The oil can prolong the
life of the bit and increase the drilling action.
•
If the bit jams in the workpiece or if the drill falls,
stop to use the machine immediately. Remove the
bit from the workpiece and analyze the cause of the
jam.
This drill has an electric brake. When the switch
trigger is released, the chuck stops turning. When the
brake is functioning properly, sparks can be visible
through the vent slots on the housing. This is normal
and is the action of the brake.
WOOD DRILLING
For maximum performance, use high speed steel bits
for wood drilling.
1. Operate the machine at a very low speed to prevent
the bit from slipping off the starting point. Increase
the speed as the drill bit bites into the material.
2. When drilling through holes, put a piece of
wood behind the workpiece to prevent ragged or
splintered edges on the back side of the hole.
METAL DRILLING
For maximum performance, use high speed steel bits
for metal or steel drilling.
1. Operate the machine at a very low speed to prevent
the bit from slipping off the starting point.
2. Hold consistent speed and pressure to avoid
overheating the bit. Applying too much pressure
can: Overheat the drill; Wear the bearings; Bend or
burn bits; and Produce off-center or irregular-shaped
holes.
English (Original Instructions)
WARNING
NOTE
3. When drilling large holes in metal, start with a small
bit, then finish with a large bit. Also, lubricate the bit
with oil to improve drilling action and increase the
bit's life-time.
5
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
5.1
CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
•
Clear the unwanted material out of the air vent with
a vacuum cleaner.
•
Do not spray the air vent or put the air vent in
solvents.
•
Clean the housing and the plastic components with
a moist and soft cloth.
6
TECHNICAL DATA
Voltage
No load speed
Chuck
Clutch
Torque
Weight without battery
Battery model
Charger model
Measured sound pressure
level
Measured sound power
level
Vibration
6
CAUTION
CAUTION
CAUTION
24 V
-1
0-550 / 0-2100 min
13 mm Keyless
21 Positions + Drill
90 Nm
1.28 kg
P2448B4, P2448B6 and
other BAM series
P2448C and other CAM
series
77 dB(A), K
= 5 dB(A)
pA
85 dB(A), K
= 5 dB(A)
wA
2
< 2.5 m/s
,K = 1.5 m/s
2
Publicidad
