Powerworks PD24D90 Manual Del Operario página 7

WARNING
• If the battery pack or charger is damaged, replace
them directly.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, understand, and follow the instructions in
the battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery slot.
2. Push the battery pack into the battery slot until the
battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.6 REMOVE THE BATTERY PACK
Figure 8
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
WARNING
Always wear eye protection.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
4.1 ADJUST THE TORQUE
Figure 9
The proper setting depends on the job and the type of
bit, fastener, and material you will be using. In general,
use greater torque for larger screws. If the torque is too
high, the screws may be damaged or broken.
1. Turn the torque adjustment ring clockwise to
decrease the torque.
2. Turn the torque adjustment ring counter-clockwise to
increase the torque.
NOTE
Torque adjustment is only active under driver mode.
4.2 ADJUST DIRECTION OF
ROTATION
The machine has the direction button (forward/reverse
lock) above the switch trigger to change the direction of
the bit.
Figure 10
1. When the direction button is on the left side of the
switch trigger, the bit direciton is forward.
2. When the direction button is on the right side of the
switch trigger, the bit direction is reversible.
English (Original Instructions)
3. Put the direction button in the OFF (center
lock) position to help decrease the possibility of
accidental start when not operating.
WARNING
Release the switch trigger and let the chuck come to a
complete stop to stop the machine.
WARNING
Let the chuck come to a complete stop before
changing the direction of rotation.
The machine does not operate until the direction
button is pushed fully to the left or right.
4.3 ADJUST THE TWO-SPEED GEAR
BUTTON
Figure 11
The machine has a two-speed gear train designed for
drilling or driving at LO (1) or HI (2) speeds. A slide
switch is on top of the machine.
1. When you use the machine in the LO (1) speed, the
speed decreases and the machine has more power
and torque.
2. When you use the machine in the HI (2) speed, the
speed increases and the machine has less power
and torque.
WARNING
Use LO (1) speed for high power and torque
applications and HI (2) speed for fast drilling or driving
applications.
4.4 START THE MACHINE
Figure 12
The machine can not work until the direction button
is pushed fully to the left or right. Do not operate the
machine at low speeds for extended periods of time.
1. Hold the machine firmly, with one hand on the main
handle and one hand on the auxilliary handle.
2. Push direction button to the left or right.
3. Push the switch trigger to turn the machine ON.
This machine is equipped with an electric brake. When
the trigger is released, the electric brake engages
automatically to quickly stop rotation.
5
NOTE
NOTE
NOTE
EN