oklahoma joes Canyon combo 24203004 Guía De Montaje página 46

Troubleshooting (continued)
Problem Possible Cause
Burner(s) will not light PIEZO PUSH-BUTTON AND ROTARY:
using ignitor. •Push-button sticks at bottom.
•Sparking between ignitor and electrode.
Burner(s) will not •See "GAS ISSUES:" on previous page.
match light.
•Match will not reach using match holder.
•Improper method of match-lighting.
Low flame, drop in gas •Out of gas.
flow.
Flames blow out. •High or gusting winds.
•Low on LP gas.
Flare-up.
•Grease buildup.
•Excessive fat in meat.
•Excessive cooking temperature.
Persistent grease fire. •Grease trapped by food buildup in
trough
Flashback... •Burner and/or burner tubes are blocked.
(fire in burner tube(s)).
Prevention/Solution
•Replace ignitor.
•Inspect wire insulation and proper connection. Replace ignitor wires /
electrode assembly if insulation is broken.
•Use long-stem match (fireplace match).
•See "Match-Lighting" section of Use and Care.
•Check for gas in LP cylinder.
•Turn front of grill to face wind or increase flame height.
•Replace LP cylinder.
•Clean trough / burner and inside of grill/firebox.
•Trim fat from meat before grilling.
•Adjust (lower) temperature accordingly.
•Turn regulator control knob to OFF. Turn gas off at LP cylinder. Leave
lid in closed position and let fire burn out. After grill cools, remove
and clean all parts.
•Turn knob to OFF. Clean burner and/or burner tubes. See burner
cleaning section of Use and Care.
46
OKLAHOMAJOES.COM