Publicidad
Idiomas disponibles
Idiomas disponibles
ZeroWater
Filter Bottle
®
Use and Care Instructions
Please read before first use.
INSTRUCTIONS BEFORE INSTALLING CARTRIDGE
AND FIRST USE
1. Clean all plastic components and filter cartridges by washing and rinsing
thoroughly with warm water only. Rinse the Filter Bottle thoroughly when washing
with soap.
2. Note: the Filter Bottle components, filter cartridges and TDS meter are not
dishwasher safe.
3. Discard all plastic bags. This may be a suffocation hazard to young children.
A
ASSEMBLY
1. Take the lower chamber and place the lower chamber divider
rim firmly on the top. The rippled part of the white rim should
be overlapping the lower chamber. If assembled upside
down, there will be leakage. Be sure it fits tightly on the
lower chamber (see ZeroWater
on page 4).
2. Screw float valve tightly into hole on bottom of lower
chamber (inset A). Do not prop the Filter Bottle on the float
valve once assembled, as it is fragile and will break.
3. Place the lower chamber on top of your cooler with the
float valve fitting inside the cooler's reservoir (see Using
Your ZeroWater
®
on page 6).
4. Install filter cartridges now, using steps 1 and 2 from
instructions on next page.
5. Place the upper chamber on top of the lower chamber. Be
sure that the lower chamber divider ring is tightly affixed
around the lower chamber (see ZeroWater
components on page 4).
Filter Bottle components
®
Filter Bottle with a Standard Water Cooler
USE AND CARE
Filter Bottle
®
5
Publicidad
