Publicidad
Idiomas disponibles
Idiomas disponibles
10
USE AND CARE
Operating the TDS Meter
CHANGING THE TDS METER BATTERIES (two 1.5v button cell)
1. Use a fingernail to remove the cap at the end that says "TDS".
2. Replace the old batteries with two new batteries (Battery Type LR44).
3. Replace the cap.
UNDERSTANDING THE TDS METER
The TDS meter helps you put a number on what your taste buds are already telling
you about what's in your water. It measures for the things in water that can give it
a taste. The higher the reading on the water, the more substances dissolved in your
water.
For a more scientific explanation, it is showing you the total number of detectable
dissolved solids in water. With the push of a button, the electrodes in the bottom
of the tester measure the amount of ions in the water and convert that amount
to a number that displays on the screen. The number represents the amounts of
detectable dissolved solids in parts per million that exist in your water sample.
The meter is primarily used to indicate ZeroWater
may also be used as a simple method to compare water quality by displaying
the Total of the Dissolved Solids (TDS) in parts per million only. The meter does
not specify what substances comprise the Total. The meter should not be used
to assess the safety or purity of water, which should only be undertaken by a
qualified laboratory.
BATTERY
COMPARTMENT
ON/OFF
MAXIMUM
IMMERSION
LEVEL
ALWAYS CHANGE FILTER CARTRIDGE
WHEN TDS METER READS "006"
1. Remove the cap from the end of the
TDS Meter.
2. Push the "ON/OFF" button. The meter
should read "000".
3. Place the end of the meter in one inch
of water. Do not fully submerge the
TDS Meter; this may short circuit the
battery.
4. Wait a few seconds for the reading
to stabilize. You can read the number
when you remove the meter from the
water.
5. Do not use in hot water.
filter replacement at 006. It
®
Publicidad
