Publicidad
Idiomas disponibles
Idiomas disponibles
FILLING THE FILTER BOTTLE WITH TAP WATER
1. Remove lid.
2. Slowly fill the upper reservoir with cold tap water. Be careful not to dump water
too quickly into the upper chamber when the lower chamber is empty because
it may tip and spill.
3. Allow water to pass from the upper chamber through the filters to the lower
chamber. Water will be ready to drink in several minutes.
4. Test the water using the TDS meter to confirm a "000" reading.
5. If it doesn't read "000", flush the water out and pour new water through.
6. Do not over fill. The first time you fill your Filter Bottle it will take extra water to fill
the cooler reservoir. When water in the lower chamber reaches the divider rim do
not put any more water in the upper chamber, as it may leak. The upper chamber
is not designed to be a long term reservoir.
Safety Precautions:
unknown quality without proper disinfection before or after the system. Individuals
requiring water of specific microbiological purity should consult their physician.
Unless notified otherwise, municipal water is potable.
Do not use with water that is microbiologically unsafe or of
USE AND CARE
7
Publicidad
