Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1. Place the wheels (№10) on the axis of the wheel support (№11), then put the screws firmly to main-
tain them. (Fig. 1)
2. Clip the wheel covers to cover the end of the axes. (Fig. 1)
3. Assemble the handle, by taking the central part (№4) and fixing it on the lower part of the handle
(№8), using the screws provided (№6) and the corresponding fast tightening nuts ( №7). (Fig. 2)
4. Now go up the upper part of the handle (№1) to the central part (№4), using the screws provided
(№6) and the corresponding fast tightening nuts (№7). (Fig. 3)
5. Use the cable clamps (№3) to secure cables. (Fig. 4)
WARNING
•
If one or more elements are/are damaged or missing, not to use the machine, this could be extremely
dangerous. Then contact our Voltr / Sweeek after -sales service, to indicate the parts concerned.
•
It is imperative not to try to modify the product or to try to adapt non -compatible accessories / not
recommended by Voltr / Sweeek; It would be very dangerous and could cause significant damage
and injuries.
•
Do not try to start the device before having completely assembled and verified that all the elements
are properly mounted.
USE OF YOUR ROTOVATOR
RUN THE WHEELS
•
Make sure the wheels are noted before
trying to start. These are provided only for
moving the machine.
•
To raise the wheels, pull the locking (A),
note the structure of the wheels (B) and
release the locking latch (A) at the level of
the hole provided for this purpose.
•
The wheels will then be in a high position
and your machine is ready to start.
40
A
B
30/10/2023
Publicidad
